GooseBumps - Clear Texture Spray

Use GooseBumps to achieve:

Tiny speckles, like the texture on a wall (spray from approx. 12" from surface with a forceful spray)

Larger dots/specks, like rain drops (spray from approx 8-10" away and push slowly on the sprayer)

Laminated look, like plastic (spray much closer and repeat until covered - NOTE: this does take longer to dry)

One very important point I'd like to share about GooseBumps is that it does require clean up when finished. By taking an extra minute or two to thoroughly rinse out (flush) the spray mechanism, it will provide wonderful and consistent results when used again.

Failure to clean as suggested may result in a clogged or frozen spray head (and our recommendation in that situation, unfortunately, is to replace the spray head with a new one).

Recommended cleaning method after use:

1. Unscrew and remove the spray head from the bottle.
2. Place the straw in plain water (in another bottle - or sink with water, etc) and spray until water flushes through the unit.
3. Remove from water and continue to press spray head until only air comes out of the sprayer.
4. Wipe any excess water from the outside of the straw (to prevent diluting) and return the spray head to the GooseBumps bottle.

Note: Other methods of cleaning (such as running the spray head under water, etc), and none of the other methods provided the reliability for consistent and good results such as the method recommended above just in case you were wondering.